Sealants
Waterproofing
Flooring
Coatings
Grouts
Concrete Repair
Adhesives
SpECgrout C3 is supplied in 25kg sealed polyethylene bags and only requires the addition of the specified amount of clean water to produce a fluid grout for pouring or pumping into large voids under machine base plates or between structural units.
SpECgrout C3 consists of Portland cement, selected graded silica aggregates and additives. The low water/powder ratio ensures a grout of high compressive strength and excellent flow characteristics.
TYPICAL USES
SpECgrout C3 is recommended for grouting gaps where the thickness is not less than 75mm and not
greater than 500mm.
In general, pre-bagged cementitious grouts without aggregate are only suitable for gaps up to 100mm. Grouting larger gaps normally requires the addition of larger aggregate to reduce the exotherm produced during the hydration process and the consequent risk of thermal cracking.
SpECgrout C3 contains aggregate that reduces excessive heat build up making the product especially suitable for deep voids under machine base plates, voids around and beneath ground tanks and large bolt pockets.
Supplied in a 25kg bag yielding 12.35 litres when mixed. Can be applied from 75-500mm depending on application. Primer not required. Curing agent required.
